Equipment for calibrating and adjusting
Change date = 20070528 20:42:14
 
Art.Nr.                     30
Type                   PM3384A
Brand - Merk           Philips
Article - Artikel      Oscilloscope Analog + Digital 100 MHz 4 channel
Category               Oscilloscope


Operating Manual       X         Service Manual X           GPIB X











--------------------------------------------------------------------------------
True 4 channel oscilloscope Analog and Digital

Vertical
* 2 mV .. 5 V per division
* AC, DC, GND
* 1 M Ohm, 50 Ohm
* Bandwidth > 100 MHz
* Risetime < 3.5 nsec

Horizontal
* 20 nsec .. 500 msec per division
* 10x magnifier
* dual delayed timebase with trace separtion
* Trigger

Trigger
* Per channel +-
* Edge, TV
* Channel, Comp, External
* AC, DC, LF reject, HF reject

TV trigger
* TV, HDTV
* Positive, Negative
* Field 1, Field2, Lines

Autoset

Cursor measurements
* Vertical
* Horizontal
* Delta T
* 1 / Delta T = Frequency
* Phase
* Delta V
* V1 + V2

Digital mode
* 200 MHz Real Time and Radom Sample Rate
* 8 bit Resolution
* 16 bit Memory
* Record Length 32 K
* 2..4096 Avarage to 16 bits
* 5 nsec Peak Detection
* 50 msec .. 200 sec per division Roll Mode Timebase
* 2..32 Horizontal Magnification
* Delay : Time-Delay, Pre-Trigger, Event-Delay

Calculated Measurements
* Volt : DC, RMS, Minimum, Maximum, Peak to Peak, Low Level, Hogh Level,
Overshoot, Preshoot
* Time : Frequency, Period, Pulsewidth, Rise Time, Fall Time, Duty Cycle
* Delay between edges
* Integrate, Differentiate, FFT spectrum

AUTOCALIBRATE
There are no calibration points under the cover.
The full calibration is done by a front knob "autocalibrate" after warmup.

RS-232 interface
GPIB interface

Options included
* IEEE/GPIB interface
* Extended Memory
* MATH+ processor

Manuals included
* User Manual
* SCPI Programming Manual
* Reference Manual
* Guide to Mathematics Functions and Pass/Fail Testing

Size : 139 mm H x 341 mm W x 481 mm L
Weight : 9.5 kg



Back
 
Kaartenbak home