RACAL TRA3900

Layout front panel

	+---------------------------------------+
VOLUME	|		Display 		|	NET	COMSEC
	+---------------------------------------+
	|1	2	3	PWR	FN	|
 RF	|4	5	6	MODE	CALL	|
	|7	8	9	PQ	IC	|
ANT	|TEST	0	Down	Up	Enter	|	AUDIO	AUDIO
	+---------------------------------------+

Switch VOLUME for on/off volume
Wait til "RADIO FAULT", push Enter
"ZAL TAMPER" push Enter
"INIT REQD" switch COMSEC on INIT push Entere
  When "ZEROISED" wait til "RADIO FAULT" and push Enter til "INIT REQD"
Wait til "INIT DONE". This can take a while.
Switch COMSEC to CLR. Radio is now ready for use.

After switch off and later switch on, you can get the message "SWITCH OFF".
Switch the radio than off and direct on.
You get then "RADIO FAULT" push Enter, "ZALL TEMPER" Enter and the frequency
is in the display.
For frequency change set the VOLUME swith to SET while holding the little
switch outside the case above the knob.
In the display is "pd-------". Use the UP key til "NET CI>>" is displayed.
Push Enter and Up.
Now the frequency is displaed. After an Enter uou can enter the new frequency
between 30 and 108 MHz.
The knob NET is the channel selector for channels 1 to 8.

Under SET there is a menu with configuration.

Specs

Frequency	30 .. 108 MHz	25 kHz step size
Preset Chanels	8
Hopping		All frequency, 4/16/256 user specified, 256 orthogonal
Output Power	100 mW, 5 W, 20 W
Power Supply	12 V or 24 V
Squelch		150 Hz
Environment	-40 C .. +70 C, EMP protected
Size		90 x 230 x 205 mm 4.4 kg
Weight		6.1 kg with battery