|
Editorial Board Page iii |
|
Preface Page ix Alan T. Riga, Gerald H. Patterson |
|
Thermal analysis and coal assessment: an overview with new developments Pages 1-9 S.St.J. Warne |
|
The thermal decomposition of coprecipitates and physical mixtures of magnesium-iron oxalates Pages 11-26 R.Glenn Rupard, Patrick K. Gallagher |
|
Alternating thermal analysis techniques Pages 27-39 Rudolf Riesen, Georg Widmann, Rolf Truttmann |
|
Reconciliation of Arrhenius and iso-conversional analysis kinetics parameters of non-isothermal data Pages 41-48 John P. Elder |
|
AC calorimetric aspect of dynamic differential scanning calorimetry Pages 49-52 Ichiro Hatta |
|
DSC enthalpy of vaporization measurements of high temperature two-phase working fluids Pages 53-63 Dwight D. Back, Lawrence R. Grzyll, Mary Corrigan |
|
Characterization of microporous carbons by using TGA curves measured under controlled conditions Pages 65-73 M. Jaroniec, R.K. Gilpin, J. Ramler, J. Choma |
|
Sinusoidal temperature treatments in thermal analysis Pages 75-85 Dun Chen, David Dollimore |
|
Heat-flux calorimetric method for the determination of spontaneous oxidative heat rate of active carbon containing oxidizable/volatile organics Pages 87-94 Gene G. Wu, David J. Leggett |
|
Reutilizing and retesting of parallel plate sensors in dielectric thermal analysis Pages 95-103 John Q. Whitley, Robert P. Kusy |
|
Influence of proton ionophore and negative sites on the dielectric behavior of plasticized poly(vinyl chloride)s Pages 105-123 John Q. Whitley, Robert P. Kusy |
|
Simultaneous dynamic mechanical analysis and dielectric analysis of polymers Pages 125-129 David D. Shepard, Benjamin Twombly |
|
Decomposition of vinylidene chloride copolymers in the presence of selected transition metal halides Pages 131-137 B.A. Howell, J.R. Keeley |
|
Thermal degradation characteristics of vinylidene chloride/2-[3,4-(1,1-dioxycyclopentyl)phenyl]ethyl acrylate copolymers Pages 139-146 B.A. Howell, B.B.S. Sastry, S.I. Ahmed, P.B. Smith |
|
The property-performance differences between two blended polypropylene fibers Pages 147-155 Jonathon A. Foreman, Ken A. Klinger, Michael Wolkowicz |
|
Mechanical reinformcement and thermal transition behaviors in nylon 6-b-polyimide-b-nylon 6 triblock copolymers Pages 157-169 F.W. Harris, B.P. Livengood, H. Ding, F.-L. Lin, S.Z.D. Cheng |
|
Dynamic mechanical analysis (DMA) and low temperature impact properties of metallocene polyethylenes Pages 171-179 L. Woo, Michael T.K. Ling, Stanley P. Westphal |
|
Polyethylene structural heterogeneity by thermal and rheological techniques Pages 181-189 Stanley P. Westphal, T.K. Ling, L. Woo |
|
A TGA technique for determining graphite fiber content in epoxy composites Pages 191-199 R.Y. Yee, T.S. Stephens |
|
Determination of enthalpy relaxation times using traditional differential scanning calorimetry for glycerol and for propylene glycol Pages 201-209 Patrick M. Mehl |
|
New test methods to determine the causes of failures in ABS drain waste and vent plumbing systems Pages 211-220 James W. Mason |
|
Applications of thermal analysis to development of gas generant formulations used to inflate automobile airbags Pages 221-231 I.V. Mendenhall, S.F. Reid |
|
Versatility of the application of thermal analysis to the simulation of gas desulphurisation Pages 233-241 K. Wieczorek-Ciurowa |
|
DSC analysis for the evaluation of an energy storing wallboard Pages 243-251 D. Feldman, D. Banu |
|
Author index Page 253 |
|
Subject index Pages 255-258 |