This subsystem configures the noise figure measurement.
Command tree: [SENSe<Ch>:]NFIGure...
Qualifies whether the analyzer assumes an ideal T0 source noise.
<Ch> |
Channel number. If unspecified the numeric suffix is set to 1.
|
<Boolean> |
ON | OFF – Switches the LO oscillator on or off. |
*RST value |
OFF
|
SCPI, Command Types |
Device-specific, command or query
|
Example: |
See Noise Figure Measurement (condensed programming examples)
|
Selects sequential or simultaneous measurement mode.
<Ch> |
Channel number.
|
<Boolean> |
ON | OFF – Sequential or simultaneous measurement |
*RST value |
ON
|
SCPI, Command Types |
Device-specific, command or query
|
Example: |
See Noise Figure Measurement (condensed programming examples)
|